Sharper Image EC-WS115 Manuál s instrukcemi stáhnout pdf (Strana 16)

Wing screw for adjusting

cutting depth

OPTION 3: USING THE CARRIAGE ASSEMBLY AND GUIDE RAIL

Install the guide rail 2-3/4 inches / 70mm from the intended cut. Take care to ensure that

the guide rail is properly clamped in place and double check your measurements. Attach

the carriage assembly to the base plate by aligning the base plate properly and attach the

pressing plates. Make sure that the pressing plates are securely fastened. The AWS should

be immobile within the carriage assembly. Slide the carriage onto the guide rail and proceed

to cut. Maintain even cutting pressure. Adjusting cutting depth should be:

Loosenthewingboltonthedepthindicatorandmovethebaseoorupanddowntothe

desiredcuttingdepthandtightenthewingnuttox

thebaseoor.

Remembertotightenthewingboltafteryounishthe

adjustment of the cutting depth each time.

Carriage Assembly

Guide Rail

Figure-15

Figure-16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Žádné komentáře

Sharper Image EC-WS115 Manuál s instrukcemi Strana 16