Sharper Image EC-WS115 Manuál s instrukcemi stáhnout pdf (Strana 15)

CAUTION!

Allow the saw blade to do the work, applying excessive forward pressure to the tool will slow

down the RPM’s and burn up the motor, which voids the limited warranty of the tool.

This tools should only be used for cutting on a horizontal surface.

Be sure to follow daily maintenance before and after each use.

OPTION 1: FREE-HAND CUTTING

1. Ifyouarecuttingstoneortilelessthan20mm(3/4”)thick,thecutcanbedoneinone

pass (allow saw blade to do the work).

2. If you are cutting stone or tile more than 20mm thick you will need to make the cut in

twopasses.Adjusttheheightto15-20mmfortherstpass,thenadjustthesawblade

below the stone for the second pass ( allow the saw blade to do the work).

3. Adjusttheamountofwaterowtocoolthebladeandremovethewaste,excessive

waterowwillgetinsidethetoolandtriptheGFCI.

4. Set the base plate on the workpiece and align to the cutting mark on the base plate

to cut line on stone.

5. Press the on/off switch to start the motor and allow the tool to attain full speed before

starting to cut.

6. Advancethetoolslowlyallowingthebladetodothework,keepingthebaseplateat

on the stone and the cut mark in line with your cut line.

7. Slowthecuttingspeedforthelast1/2”topreventthetileorstonefromchipping.

OPTION 2: USING THE RULER GUIDE

Install the ruler on the AWS-110 by inserting the arms into the appropriate slots on the

base plate and tightening the screws to secure the ruler in place. When using the edge

of the stone as your guide, install the ruler so that it is below the base plate (Figure-13).

Measure the distance from the edge to the intended cut and use this measurement to set

the ruler at the proper distance. When using a straight edge as a guide, install the ruler so

that it is above the base plate (Figure-14). Measure the distance from the straight edge

to the intended cut and use it to set the ruler at the proper distance. When cutting, simply

keep the ruler in contact with the straight edge while maintaining even cutting pressure and

your cuts will be straight.

Figure-14

Figure-13

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Žádné komentáře

Sharper Image EC-WS115 Manuál s instrukcemi Strana 15