Sharper Image SC050 Battle Beasts Manuál s instrukcemi

Battle BeastsDueling Robotic AnimalsSC050 InstructionsFor ages 8 and older.Read and save these instructions.

Auto Off: If a button is not pressed on the remote control within 3 minutes, the remote turns off automatically. If the Battle Beast does not receive

Press M2 and the desired direction button for more than 5 seconds. The Beast finishes the corresponding attack route.Because the Beast’s motor will be

Left direction button + M1: Go to the rear of the opponent from the left and fire CANNON.Right direction button + M1: Go the rear of the opponent from

Up Direction button + M1: Go the side of the opponent from the left and attack.Down button + M1: Go the side of the opponent from the right and attack

Left button + M2: Go to the back of the opponent from the left and fire CANNON.Right button + M2: Go to the back of the opponent from the right and fire

Up button + M2: Go the side of the opponent from the left and attack.Down button + M2: Go to the side of the opponent from the right and attack.Macro

Game Rules TableLife EnergyDirec-tionsCannon Shots Cannon Reload TimeRifle Reload TimeShield TimeIm-mobile TimeDisarm Time10 8 40 4 sec. 3 sec. 4 sec.

Immobile Time: When the Beast is shot by Cannon or Rifle, it cannot move for 2 seconds. However, the Rifle is still active.Disarm Time: When confronted

Dance IndicatorsPower On Dance: After powering on your Beast, it plays a dance as detailed below:Forward ➞ left 45° ➞ right 90° ➞ left 45° ➞ horn for

Left Eye LEDCannon In Combat status, ON means reload-ed; OFF means reloading or cannon shots depleted.Cannon Firing Indication When firing cannon, it

Top LEDPrecombat Status IndicationBetween power on and combat status, green LED blinks 3 times, then the orange LED blinks 3 times.Life Energy Indica

Attacked by Opponent BodyWhen attacked by opponent body, red LED flashes 3 times, then it’ll be on for 0.6 seconds. It’ll return to Life Energy Indicat

Statement of FCC ComplianceWARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the

Statement of FCC Compliance• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect th

WarrantyWhat Is CoveredThis warranty covers any defects in materials or workmanship, with the exceptions stated below.How Long Coverage LastsThis warr

Table of ContentsWarnings ...5Introduction ...

Head H1 or H25Warnings• Do not mix old and new batteries.• Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel-Cadmium).• Only use

IntroductionEach of the Battle Beasts has a sophisticated remote that features dual command buttons and an eight-movement direction pad. The blue Beas

Beast1. There are two battery compartments located under each Battle Beast. Remove the screw and the battery compartment door from the large battery

Remote Control1. The battery compartment is located in the stand. Look for the silver screw.bm1 m22. Remove the screw and the battery compartment

Buttonsbm1 m2HORN: To start combat, slide one Battle Beast’s channel switch to “A” and the other Battle Beast’s channel switch to “B.” To enter Combat